
Irvine Chimneys, Scanned and Measured
Book an Irvine Camera Inspection
Leave your name, phone and street. A call back brings an Irvine day and ask whether the fireplace is masonry or factory-built.
Irvine ZIP Codes on Our Route
Give us the street when you call. It tells us the drive from North Hollywood and, often, what kind of fireplace to expect.
What to Book in Irvine
Irvine village homes with gas units can add a vent and label record to any sweep.
Chimney Sweep in Irvine
Creosote and soot cleared first, so the camera scan that follows reads the real tile and not the buildup.
Learn MoreChimney Inspection in Irvine
Level 1, 2 or 3 to NFPA 211, each part photographed with its measurement written beside the photo.
Learn MoreChimney Repair in Irvine
Crown, joint and liner repairs sized to the cracks and gaps the report measured, and no further.
Learn MoreFireplace Inspection in Irvine
Firebox panels, damper and smoke chamber checked, with crack lengths and hearth clearances noted down.
Learn MoreFireplace Repair in Irvine
Refractory, damper and hearth fixes limited to the items the inspection photographed.
Learn MoreChimney Level 2 Inspection in Irvine
A full camera scan of the flue for a sale, with a still of each joint and the readings in the report.
Learn MoreChimney Cap Installation in Irvine
Stainless caps cut to a measurement of the flue tile, with spark arrestor mesh fitted on top.
Learn MoreChimney Flashing Repair in Irvine
Step and counter flashing traced to the point where water enters, then replaced at that point.
Learn MoreChimney Masonry Repair in Irvine
Tuckpointing on the joints the report marked, with mortar matched to the brick around them.
Learn MoreChimney Rebuilds in Irvine
Partial or full rebuilds when the measured damage is past what a repair can hold, permits handled.
Learn MoreFireplace Cleaning in Irvine
Firebox, glass and hearth cleaned, with anything out of the ordinary photographed for the record.
Learn MoreGas Fireplace Cleaning in Irvine
Gas fireplace cleaning with a CO reading taken and written down, pilot and burner included.
Learn MoreGas Fireplace Repair in Irvine
The failed part found by testing, named in the visit notes, and replaced on its own.
Learn MoreFireplace Remodel in Irvine
Surrounds, mantels and conversions that start from a measured check of the firebox and flue.
Learn MoreFireplace Inserts in Irvine
Inserts chosen from the firebox and flue dimensions we take on the first visit, liner included.
Learn MorePellet Stove Repair in Irvine
Pellet stove faults tested part by part, so the invoice covers the one part that failed.
Learn MoreWood Stove Repair in Irvine
Baffle, firebrick, door gasket and combustor checked for wear. Only the worn ones get swapped.
Learn MoreGas Logs in Irvine
Vented or ventless sets sized to the firebox measurements and the room, gas line included.
Learn MoreWhat the scan and the tape show in Irvine
Masonry is the exception in this city of planned villages, where half the housing has gone up since about 2002. A gas or metal unit lives by its label and vent, so ours is a parts inspection, and we state which parts match the listing and which do not. About ten miles inland, salt is mild and gusts are the bigger worry in fall and winter. A loose cap gets recorded with its fastener count, and 2014 shaking is a reason to check pipe joints in older villages.
The Houses
On our Irvine visits: stucco and tile village homes, attached units, and factory-built metal or gas fireplaces in nearly all.
What We Measure
Label data, vent diameter, termination cap type, and fastener count.
What the Camera Checks
Vent sections inside the framing, including joints in the older villages.
How the Repair Is Scoped
Wrong parts are named, with the correct listed match shown beside them.
See It First
Book a camera inspection for your Irvine chimney.
One visit covers the sweep, the scan and the measurements. The report with the photos comes with it.
