
Industry Chimneys, Scanned and Measured
Book an Industry Camera Inspection
Leave your name, phone and street. A call back brings an Industry day and ask whether the fireplace is masonry or factory-built.
Industry ZIP Codes on Our Route
Give us the street when you call. It tells us the drive from North Hollywood and, often, what kind of fireplace to expect.
What to Book in Industry
The few homes in Industry can ask for a plain flue record with their sweep.
Chimney Sweep in Industry
Creosote and soot cleared first, so the camera scan that follows reads the real tile and not the buildup.
Learn MoreChimney Inspection in Industry
Level 1, 2 or 3 to NFPA 211, each part photographed with its measurement written beside the photo.
Learn MoreChimney Repair in Industry
Crown, joint and liner repairs sized to the cracks and gaps the report measured, and no further.
Learn MoreFireplace Inspection in Industry
Firebox panels, damper and smoke chamber checked, with crack lengths and hearth clearances noted down.
Learn MoreFireplace Repair in Industry
Refractory, damper and hearth fixes limited to the items the inspection photographed.
Learn MoreChimney Level 2 Inspection in Industry
A full camera scan of the flue for a sale, with a still of each joint and the readings in the report.
Learn MoreChimney Cap Installation in Industry
Stainless caps cut to a measurement of the flue tile, with spark arrestor mesh fitted on top.
Learn MoreChimney Flashing Repair in Industry
Step and counter flashing traced to the point where water enters, then replaced at that point.
Learn MoreChimney Masonry Repair in Industry
Tuckpointing on the joints the report marked, with mortar matched to the brick around them.
Learn MoreChimney Rebuilds in Industry
Partial or full rebuilds when the measured damage is past what a repair can hold, permits handled.
Learn MoreFireplace Cleaning in Industry
Firebox, glass and hearth cleaned, with anything out of the ordinary photographed for the record.
Learn MoreGas Fireplace Cleaning in Industry
Gas fireplace cleaning with a CO reading taken and written down, pilot and burner included.
Learn MoreGas Fireplace Repair in Industry
The failed part found by testing, named in the visit notes, and replaced on its own.
Learn MoreFireplace Remodel in Industry
Surrounds, mantels and conversions that start from a measured check of the firebox and flue.
Learn MoreFireplace Inserts in Industry
Inserts chosen from the firebox and flue dimensions we take on the first visit, liner included.
Learn MorePellet Stove Repair in Industry
Pellet stove faults tested part by part, so the invoice covers the one part that failed.
Learn MoreWood Stove Repair in Industry
Baffle, firebrick, door gasket and combustor checked for wear. Only the worn ones get swapped.
Learn MoreGas Logs in Industry
Vented or ventless sets sized to the firebox measurements and the room, gas line included.
Learn MoreWhat the scan and the tape show in Industry
City of Industry is nearly all warehouses and factories, and homes number only around 40. A house here still gets a full inspection, and the report starts by stating whether there is a working flue at all. Hot dry summers and mild winters do little harm by themselves, and the paved core has no real wildfire history. The 2008 Chino Hills shaking started a short way east, so an old stack merits a scan.
The Houses
On our Industry visits: a very few detached houses and rentals among warehouses, factories and industrial land.
What We Measure
Whether a working flue exists, its size, and the crown's state.
What the Camera Checks
The full flue run in an older home, including any cracks from 2008 shaking.
How the Repair Is Scoped
If the fireplace is not in use, the report says so and lists no repairs.
See It First
Book a camera inspection for your Industry chimney.
One visit covers the sweep, the scan and the measurements. The report with the photos comes with it.
