
Bell Chimneys, Scanned and Measured
Book a Bell Camera Inspection
Leave your name, phone and street. A call back brings a Bell day and ask whether the fireplace is masonry or factory-built.
Bell ZIP Codes on Our Route
Give us the street when you call. It tells us the drive from North Hollywood and, often, what kind of fireplace to expect.
What to Book in Bell
Older Bell homes on narrow lots should add a four-sided photo record to any sweep.
Chimney Sweep in Bell
Creosote and soot cleared first, so the camera scan that follows reads the real tile and not the buildup.
Learn MoreChimney Inspection in Bell
Level 1, 2 or 3 to NFPA 211, each part photographed with its measurement written beside the photo.
Learn MoreChimney Repair in Bell
Crown, joint and liner repairs sized to the cracks and gaps the report measured, and no further.
Learn MoreFireplace Inspection in Bell
Firebox panels, damper and smoke chamber checked, with crack lengths and hearth clearances noted down.
Learn MoreFireplace Repair in Bell
Refractory, damper and hearth fixes limited to the items the inspection photographed.
Learn MoreChimney Level 2 Inspection in Bell
A full camera scan of the flue for a sale, with a still of each joint and the readings in the report.
Learn MoreChimney Cap Installation in Bell
Stainless caps cut to a measurement of the flue tile, with spark arrestor mesh fitted on top.
Learn MoreChimney Flashing Repair in Bell
Step and counter flashing traced to the point where water enters, then replaced at that point.
Learn MoreChimney Masonry Repair in Bell
Tuckpointing on the joints the report marked, with mortar matched to the brick around them.
Learn MoreChimney Rebuilds in Bell
Partial or full rebuilds when the measured damage is past what a repair can hold, permits handled.
Learn MoreFireplace Cleaning in Bell
Firebox, glass and hearth cleaned, with anything out of the ordinary photographed for the record.
Learn MoreGas Fireplace Cleaning in Bell
Gas fireplace cleaning with a CO reading taken and written down, pilot and burner included.
Learn MoreGas Fireplace Repair in Bell
The failed part found by testing, named in the visit notes, and replaced on its own.
Learn MoreFireplace Remodel in Bell
Surrounds, mantels and conversions that start from a measured check of the firebox and flue.
Learn MoreFireplace Inserts in Bell
Inserts chosen from the firebox and flue dimensions we take on the first visit, liner included.
Learn MorePellet Stove Repair in Bell
Pellet stove faults tested part by part, so the invoice covers the one part that failed.
Learn MoreWood Stove Repair in Bell
Baffle, firebrick, door gasket and combustor checked for wear. Only the worn ones get swapped.
Learn MoreGas Logs in Bell
Vented or ventless sets sized to the firebox measurements and the room, gas line included.
Learn MoreWhat the scan and the tape show in Bell
Narrow lots leave little room beside a pre-war chimney in Bell, where close to 4 in 10 homes date from before 1950. We note clearance to the next wall and photograph the stack from wherever it can be seen, because old mortar can fail on any side. Damage from the 1987 Whittier Narrows quake reached older local masonry, and a repair from that time may still be up there. Our camera checks what lies behind it, while morning damp and winter rain keep testing joints.
The Houses
On our Bell visits: bungalows on narrow lots from before the war, small houses, apartments, and a dense mix of rentals.
What We Measure
Clearance to neighboring walls, mortar loss on each face, and flue size.
What the Camera Checks
Old quake repairs and shifted tile in brick stacks from the 1920s through the 1940s.
How the Repair Is Scoped
Each older repair is labeled sound or failing, and a sound one stays in place.
See It First
Book a camera inspection for your Bell chimney.
One visit covers the sweep, the scan and the measurements. The report with the photos comes with it.
